- Status Closed
- Percent Complete
- Task Type Feature Request
- Category Magicard family
- Assigned To No-one
- Operating System All
- Severity Low
- Priority Medium
- Reported Version 1.0
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: Gutenprint / CUPS Dye-sublimation drivers
Opened by pizza - 2018-03-10
Last edited by pizza - 2018-03-18
Opened by pizza - 2018-03-10
Last edited by pizza - 2018-03-18
FS#599 - Enhance Magicard driver to allow for different options on the duplex side.
At minimum, the overcoat hole is different on front vs back (eg smartcard vs magstripe).
Magstripe probably only belongs on the back, smartcard on the front.
Holokote and holopatch likely need to be different too.
Closed by pizza
2018-03-18 18:45
Reason for closing: Implemented
Additional comments about closing: It's in gutenprint now.
2018-03-18 18:45
Reason for closing: Implemented
Additional comments about closing: It's in gutenprint now.
Loading...
Available keyboard shortcuts
- Alt + ⇧ Shift + l Login Dialog / Logout
- Alt + ⇧ Shift + a Add new task
- Alt + ⇧ Shift + m My searches
- Alt + ⇧ Shift + t focus taskid search
Tasklist
- o open selected task
- j move cursor down
- k move cursor up
Task Details
- n Next task
- p Previous task
- Alt + ⇧ Shift + e ↵ Enter Edit this task
- Alt + ⇧ Shift + w watch task
- Alt + ⇧ Shift + y Close Task
Task Editing
- Alt + ⇧ Shift + s save task
Actually, given that magstripe encoder is on the opposite side from the printhead, it makes sense to limit magstripe to the "front" in this case.
Also need to support magstripe-only operation?