Gutenprint / CUPS Dye-sublimation drivers

  • Status Closed
  • Percent Complete
    100%
  • Task Type Feature Request
  • Category Magicard family
  • Assigned To No-one
  • Operating System All
  • Severity Low
  • Priority Medium
  • Reported Version 1.0
  • Due in Version Undecided
  • Due Date Undecided
  • Votes
  • Private
Attached to Project: Gutenprint / CUPS Dye-sublimation drivers
Opened by pizza - 2018-03-10
Last edited by pizza - 2018-03-18

FS#599 - Enhance Magicard driver to allow for different options on the duplex side.

At minimum, the overcoat hole is different on front vs back (eg smartcard vs magstripe).

Magstripe probably only belongs on the back, smartcard on the front.

Holokote and holopatch likely need to be different too.

Closed by  pizza
2018-03-18 18:45
Reason for closing:  Implemented
Additional comments about closing:  It's in gutenprint now.
Admin
pizza commented on 2018-03-16 20:11

Actually, given that magstripe encoder is on the opposite side from the printhead, it makes sense to limit magstripe to the "front" in this case.

Also need to support magstripe-only operation?

Loading...

Available keyboard shortcuts

Tasklist

Task Details

Task Editing