CUPS Dyesub Backends

  • Status Closed
  • Percent Complete
  • Task Type Feature Request
  • Category Magicard family
  • Assigned To No-one
  • Operating System All
  • Severity Low
  • Priority Medium
  • Reported Version 1.0
  • Due in Version Undecided
  • Due Date Undecided
  • Votes
  • Private
Attached to Project: CUPS Dyesub Backends
Opened by Solomon Peachy - 2018-03-10
Last edited by Solomon Peachy - 2018-03-18

FS#599 - Enhance Magicard driver to allow for different options on the duplex side.

At minimum, the overcoat hole is different on front vs back (eg smartcard vs magstripe).

Magstripe probably only belongs on the back, smartcard on the front.

Holokote and holopatch likely need to be different too.

Closed by  Solomon Peachy
2018-03-18 18:45
Reason for closing:  Implemented
Additional comments about closing:  It's in gutenprint now.
Solomon Peachy commented on 2018-03-16 20:11

Actually, given that magstripe encoder is on the opposite side from the printhead, it makes sense to limit magstripe to the "front" in this case.

Also need to support magstripe-only operation?


Available keyboard shortcuts


Task Details

Task Editing