- Status New
- Percent Complete
- Task Type Bug Report
- Category Magicard family
- Assigned To No-one
- Operating System All
- Severity Low
- Priority Medium
- Reported Version 1.0
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
FS#588 - Registration/Alignment issue with Black plane
K extraction appears to work well, but when printing there's a registration problem. The black layer appears to print several pixels higher than the color layers.
I'm not sure if this is something that needs a fixed offset applied, or is something that can vary printer-printer.
On my printer, the black data looks much better (but not perfect) if it's shifted down by 2 pixels. Might need to shift it over by one pixel too.
This frankly seems a bit suspicious given that the color registration is spot-on.
Or could one of the not-yet-figured-out firmware commands be there to adjust the K alignment?