- Status Closed
- Percent Complete
- Task Type Feature Request
- Category DNP/Citizen
-
Assigned To
pizza - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 1.0
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: Gutenprint / CUPS Dye-sublimation drivers
Opened by pizza - 2015-08-26
Last edited by pizza - 2019-05-21
Opened by pizza - 2015-08-26
Last edited by pizza - 2019-05-21
FS#538 - Add support for DS80DX
It has all the joy of the DS80, but also supports sheet-fed simplex and duplex operation. It's a veritable mess to support cleanly.
Closed by pizza
2019-05-21 15:11
Reason for closing: Implemented
Additional comments about closing: After some bugfixes, it's confirmed fully functional.
2019-05-21 15:11
Reason for closing: Implemented
Additional comments about closing: After some bugfixes, it's confirmed fully functional.
Loading...
Available keyboard shortcuts
- Alt + ⇧ Shift + l Login Dialog / Logout
- Alt + ⇧ Shift + a Add new task
- Alt + ⇧ Shift + m My searches
- Alt + ⇧ Shift + t focus taskid search
Tasklist
- o open selected task
- j move cursor down
- k move cursor up
Task Details
- n Next task
- p Previous task
- Alt + ⇧ Shift + e ↵ Enter Edit this task
- Alt + ⇧ Shift + w watch task
- Alt + ⇧ Shift + y Close Task
Task Editing
- Alt + ⇧ Shift + s save task
Roll operation is identical to the DS80, with a few additional commands to query duplexer status.
Duplex is only supported with Cut media, which has a different set of supported media sizes.
Backend now has a lot of the basic stuff added (status queries, media sanity checking)
Gutenprint proper needs a ton of work still, and nothing ensures correct simplex/duplex codes when using cut media, as that is dependent on the print job itself.
Gutenprint is theoretically ready now.
Found the USB VID/PID.
And programmed it in wrong. This code has been broken for two years.
Turns out the USB PID was still wrong. Corrected. Hopefully getting more feedback soon.
committed a couple of bugfixes